Delorean DMC Grill emblem belt buckle help...

dhennick99

Well-Known Member
I picked up a Delorean's DMC grill emblem and would like to make it into a belt buckle. Any ideas about how I might go about tackling this project? It seems simple enough. There are 3 prongs that hold it in place on the car. I'm thinking about sawing them off so I have a flat surface to work with. Are there any kits available for custom buckles? I'd like to avoid any welding if possible.
01262012348.jpg
 
although isnt it a bit wide

-It's not too wide to be practical. Here's an approximation of what I'm going for. I like your idea of using epoxy with a throw away buckle from another belt. I'd like to seat the buckle behind the "M". It should fit nicely between the front loops on most pants.

01262012349.jpg
 
Thats an awesome Idea!:love

I think I might have a go at that also!

I'm gonna contact my laser cutter buddy and get a few of these made up! out of aluminium!

I gonna scale it down a tad tho!

rich
 
Thanks. That 1/2" (3.8 cm) to 1-3/4" (4.4 cm) blank is definitely a possibility. Hoping I can just epoxy it behind the "M".
 
Back
Top