D

it's kind of hard to know what you're doing with no pictures, but if it's a face or mask, i'd glue the eyes to the right spot and fill over them. if you want to remove them, cover them in lots of mold release agent.
another option is to use clear resin, so you can leave the eye slit unpainted and see the eye through it.
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top