Convert Pepakura PDO to STL/OBJ

Zach94

New Member
Is there anyone that has the Pepakura software that would be able to convert a ".pdo" to an ".stl" or ".obj" for me? I'd do it myself but I have a Mac so the software isn't available to me unfortunately. If anyone could do this for me I'd really appreciate it, as I've been trying to convert this file for 3D printing for a while now.
 

Attachments

  • cyclops_foam.pdo
    235.1 KB · Views: 7

peterquill

Active Member
Is there anyone that has the Pepakura software that would be able to convert a ".pdo" to an ".stl" or ".obj" for me? I'd do it myself but I have a Mac so the software isn't available to me unfortunately. If anyone could do this for me I'd really appreciate it, as I've been trying to convert this file for 3D printing for a while now.

here you go,
but you are going to have a hard time 3d printing it,

you could try some alternatives


 

Attachments

  • cyclops_foam.obj
    42.5 KB · Views: 7

Zach94

New Member
here you go,
but you are going to have a hard time 3d printing it,

you could try some alternatives


Thanks, I'm at least going to see what I can do with it. And thanks for the alternatives too.
 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top