CONTROL BOX STRIP????

russrep

Sr Member
RPF PREMIUM MEMBER
Hi guys can any 1 point me to where I can get the right strip for the Luke ROTJ control box???
Russ..
 
I got one of those Testors "make your own waterslide decals" kits and printed one on an inkjet printer after creating it in Photoshop. Turned out good. (I'll be posting some pix when I have the time.)
 
Originally posted by franz bolo@Jan 19 2006, 10:06 PM
If you had dimensions, can you make your own?

FB
[snapback]1163175[/snapback]​
Hi again all I got is the length at 51 & half mm .But i'm after a few ........about 10 any 1???
Russ...
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top