-
Welcome to the Project Runs Forum!
This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
Done / Completed **Closed**TFA: Melted Vader Helmet (MasterEdi V2)
- Thread starter MasterEdi
- Start date
Jagjaguwar
Sr Member
C'moooooooon mooold! Just a few dozen more! :lol (Or, really, just as many as you can till the mold gives out, MasterEdi :cheers )
Even if I don't end up with one of these, it's been fantastic to see this run! Just beautiful, each and every one.
sparrowfan
Well-Known Member
found it on a vader FB group! (Fully finished one by MasterEdi)
owner ok with me posting pics
owner ok with me posting pics
Attachments
Last edited:
Kerberos23
Well-Known Member
I wouldn't think the molds would hold up for all on the list all ready. Was the master destroyed in making the molds like in the V1 Helmet, or can new molds be made? How far are we down the list now?
russellsch
Master Member
Man, that looks so GOOD!
Judging by the list, he's making the last one from the initial list. If the mold holds up, next is Halliwax, the 1st on the interest list. I think MasterEdi said this was it. However long the mold holds out, that's what gets made. Count yourself as luck that you got yours.
& post more pictures, cause that looks so damn good!
Kerberos23
Well-Known Member
Looked like it said last updated 3 weeks ago so wasn't sure if more had gone out since then. Here's a couple more pics, should be more a page back from when I first finished painting.
clancampbell
Sr Member
You guys are KILLING me here! I need one of these so badly!
Rich
Rich
I'm assuming getting to number 6 on the list is gonna be a miracle at this point. Fingers crossed...
eacnwood
Active Member
I'm with you, seeing as I'm number 7, lol...
russellsch
Master Member
I'll make you both good.
I'm #21 :cry
I'm #21 :cry
Kerberos23
Well-Known Member
oh, haven't seen much here lately. If anyone is looking for a cheap stand, Hobby Lobby has the almost usual 50% house decorations, and I picked up this hexagonal wall display for $10. I'm going to turn it upside down and glue my $8 tablet stand to the top and then spray it down with hammered black Krylon and add some rubber feet. I'd like to do so ashes/bones whatnot on top, anyone have any tips on what to use and how to glue it down?
So I'm assuming this is done or is there gonna be an attempt to get a few more pulls from the molds?
A few more pulls can happen... each one takes more time to finish out though, so at some point it will have to end. But also it's my busy time for my real job so it's hard for me to make time to cast. Your best bet to get one is to see if anyone wants to sell theirs, I've seen one sell on eBay, and in the junkyard.. I think I'm the only maker who wishes someone will do a recast for the folks here! Lol
