BFS1 Real Parts EE-3 Build

[ConvergencePro]

Got this going over at The MPPC and figured i might as well do it here too.
Im working on a all found parts Boba Fett ESB EE-3.

Parts in hand
1. 1917 Webley No1 MKI Signal Gun
2. 1977 Visible V8 Operating Engine Model- Connecting Rod
3. Four Real Molex Connectors
4. Replacement Stock for the matching one (not gunna destroy an original

Parts Needed.
5. Leather sling
6. A.S.I. 4x20 Scope
7. 3 LMK/AM Aerial Earth Connector's
8. Vintage MPP microflash tube <------ (Incorect MPP, has smaller B-hole)
9. Part under the V8 arm (ID Unknown)
10. Scope Mounting Rings (ID Unknown)
11. Red Box for Stock (ID Unknown)


Any help with these parts (especially the A.S.I. scope) would be appreciated

ill be posting updates as parts are found

Dana

 

[DL 44 Blaster]

Noice!!!!!

 

[ConvergencePro]

Just a small Update
The replacement stocks stain was a little to far gone so i striped it and restained it
i use EasyOff oven cleaner to remove the old stain from any old gun stock i wish to restore. it only needs about 6 min or so before it needs to be removed. any longer & it will start to damage the wood. anyway i used an old stain i found lying around. i think it was dark oak or something. but it got the job done. its still drying but this was the end product of the restaining.

 

[Madog]

Almost half way there. Good luck on the project. Be sure to post progress pix.

 

[Vegas Vader 2]

that looks sweet!!

 

[ConvergencePro]

just a small update. the MPP tube i have is the incorrect tube. im now looking for a Large B port hole MPP. im also going to have to get another webley stock as ive put the one i was going to use on the resin gun im selling on ebay. so ya ive worked my self backwards instead of forward, lol

 

[ConvergencePro]

not much progress.
got a hold of a v8 kit and got the stuff out of that. the flashtube is a replica mpp that's a stand in until i can get a hold of the correct mpp tube with the large B hole. the barrel ring is a custom one i made. again a a stand in untill i can locate the real deal. parts for this build are pretty damn hard to find but someday this build will be done, be it months or years down the road

 

[tango'd fett]

Nice project , will be amazing if you can pull it off. The square box on the stock has never been identified as far as i know so it could have been a scratchbuilt item they threw together. Sidewinder here does a good approximation of one in resin if you have no luck and also has casts of the lmk/fm connectors as they are seriously hard to find. ASI scopes do appear from time to time you just have to be real patient
great job so far :thumbsup

 

[ConvergencePro]

ya ive been hunting for a ASI scope going on half a year now. havent seen one yet though