Best way to attach Aluminum to resin

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


LogansRunner

Well-Known Member
Ok, what I have is a copy of the bottom half of my sidious saber in resin, and I wanted to attached the top half (emitter section) to the resin, so should I use some sort of adhesive, or try and thread it to the resin of some sort...?
-Thanks
The resin bottom I'm using now wont be permanent, just my "experimental" version.
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

ob1al

Sr Member
Hi buddy

Would it be possible to add a 1" threaded bar into the top piece?

If so, you could drill a hole in the (top and) bottom half and screw the threaded rod in, thus giving you a removable section for later replacement.

Regards

Al
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

LogansRunner

Well-Known Member
sidsaber3.jpg

Took a quick shot of the original pull of my sidious saber, cleaned it up a bit.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top