Does anyone out there provide (or know someone who does) aluminum fabrication? I just need pieces for Batman utility belt buckles that I designed cut from a sheet (1/8" & 1/4") of aluminum. Any help would be appreciated!
Batman belt aluminum fabrication
- Thread starter BROTHERFOSTER
- Start date
cavedwellar
Sr Member
This is an awesome project, I don't know why you haven't gotten any replies to this.
Thanks! I'm a bit surprised myself....
CustomPropSculptorGuy
Well-Known Member
I would guess because it is the cost of the manufacturing. I know a lot of people in the area here, but I don't know if they'd take on the project.
I just need someone to cut out the parts (water jet, etc). and I would do the assembling.
Ghadrack
Sr Member
I'd guess it's because you posted in the costuming section and the thread title doesn't call out for a person to cut your project. Try the main propr forum, or off topic and I bet you'll find a person who can do it.
The Costuming forum may not be on the radar for the machinists on the forum.
The Costuming forum may not be on the radar for the machinists on the forum.
Darth Mule
Sr Member
PM sent
Thanks Chris!!
JasonofTigerclaw
Well-Known Member
If you haven't found anybody yet, try contacting MikeTribal on the board here (one of the Zeist guys). He does a lot of waterjet cutting of tsuba and other parts (as well as his own casting in resin and bronze/brass) and is currently doing a set of waterjet cut "Eli Machetes".
Tell him I sent you and he should be able to help.
Tell him I sent you and he should be able to help.
Much appreciated. Thanks!
