Mara Jade's Father
Master Member
This is the rgriesbeck 3D printed and General Frost finished Baby Groot.
The final step was planting the little guy. I wanted to use a found item for the pot and found something decent at Michaels for 60% off.
I sanded the outside of the pot as smooth as I could without major remodel and painted. used the foam inside the pot but cut it so that it say lower. The Groot had its own round and deep base so I used Model Magic to mold up and around the base. I used Elmer's Glue All to to bod the faux dirt to the Model Magic. I sealed the faux dirt with a spray craft sealer.
The final step was planting the little guy. I wanted to use a found item for the pot and found something decent at Michaels for 60% off.
I sanded the outside of the pot as smooth as I could without major remodel and painted. used the foam inside the pot but cut it so that it say lower. The Groot had its own round and deep base so I used Model Magic to mold up and around the base. I used Elmer's Glue All to to bod the faux dirt to the Model Magic. I sealed the faux dirt with a spray craft sealer.
