3D Print Test - Anyone?

[MonkeyInk]

Relatively new to the forum so not sure where best to post this. I have a resin sla printer, and some new resin in from a supplier to try.
Anyone need anything printer, beauty of my resin printer is the detail. Need to do a few prints to get test it out, if anyone wants anything printed then let me know and ill use as the test. If you actually want the piece after I will only charge for the delivery. I am UK based, but I would think only postage to the USA would be cheaper than paying someone to print for you.
Or PM if you have a project going on and this would be helpful.
Only downside to it is that the bed size isnt massive, its 14cm height 14cm width and 8 cm depth. Printed using stl. files but I can convert obj. files. Allow a bit of room for support material also.
Attached a few examples of previous prints.

 

[kamandi]

Blender can read an obj file and export an stl.

I have an Anycubic Photon Mono X on pre-order. I'm looking forward to printing some stuff.

What kind of resin do you like?

 

[MonkeyInk]

Hey. O yeh I know re blender it was more if someone wanted me to print something if they could send over as an stl or I will convert the obj file if that is all we have. I use Blender, Fusion 360 and Z brush for my sculpts.

I have the Anycubic Photon, not the X the original. Its great you've made a good choice. Ive had mine now for a year and a half and dont regret it at all, especially for high detail pieces and using for masters for molds.

I have always used Anycubics resin as others I used just didnt seem to have the same quality. Some didn't cure properly and so on I had a lot of issues. However I was contacted by Elegoo and given samples to try