Recent content by hooper

Re: Pepakura BIKER SCOUT HELMET Build - Picture Heavy DAY 3 just press the "print screen" key on your keyboard, open any picture editor you may have (m$ paint will do), then open a new document and paste. :)

Re: Pepakura BIKER SCOUT HELMET Build - Picture Heavy DAY 3 haha...wish i could mate, but i've two little things sat here that pretty much put pay to that (a one year old and a three year old)! i'm having a play with plasticard (styrene sheet) to try and eliminate as much use of bondo as...

Re: Pepakura BIKER SCOUT HELMET Build - Picture Heavy DAY 3 looking good mate, my biker scout build has near enough ground to a halt....can't seem to get myself motivated at all :( looks like you managed to chop it fairly well too :)

Hats off to you mate, simply stunning. Sent from my Desire HD using Tapatalk

Cheers mate, its going pretty well at the moment so fingers crossed....and yes, the stuff sticks like **** to a blanket! Sent from my Desire HD using Tapatalk

Milliput is essential stuff!! I went through a boat load of it on my stormtrooper helmet but it was more used for detail work and edging....not sure i'd want to use it instead of resin, it would cost a fortune!

It wasn't too bad to be honest, I coated the outside with a layer of resin (its one I acquired from work and doesn't go as hard as fiberglass resin). I should really have done it in a few goes instead of all at once! It's really easy to work with a Sharp knife, plus it sands down too. Sent...

After having a little break from my stormtrooper build I decided to get cracking with my Scout Trooper lid. After certain issues I had with the last build, I decided to try and get it somewhat accurate before the bondo was applied. As this is more like a sculpt and im going to be either vac...

Hurry up and get one finished! Lol. Excellent work mate, you might have made a rod for your own back here though as I can see you getting swamped with requests for them ! Sent from my Desire HD using Tapatalk

Mines good mate, on with my scout trooper lid now. The pep is finished and am at the resin stage. This one won't be wearable as It's going to be sliced up. I'm also in the process of making my own vac forming table! Looks like you have your casting method sussed! Looks mint. Sent from my...

"Hell I like you....you can come over to my house and **** my sister" Full Metal Jacket (could fill a thread with the quotes from that one) "And thennnnnnnnnnnnnnnnnnnn........." Dude, Where's My Car "***** t**y-******* ******" Team America

me too...you don't see a thing but it sends my (extremely vivid) imagination into overdrive. Freaks me out everytime.

any chance of a Voorhees hockey mask mate?

Re: Rapunzel ( and Flynn ) WIP for Halloween! very interesting project :) the attention to detail is astounding, and i bet it's going to look awesome when finished! :thumbsup

I would just like to thank everyone for their kind words, support and encouragement that I have recieved during and post-build. Without that support I really doubt I would have gotten the results I have!!!!! thanks again!