Recent content by DrConstantine

Yes there is, they are Zorro lighters

So, here's a bit of an update: All the blank lighters and new inserts have come in! I am making jigs for the lighters so that they are as consistent as I can make them! Right now I am waiting for my enclosure to come in so I can get these started and not be breathing atomized Brass!

UPDATE! The lighters came in, so as promised, here are the photos showing the lighter inserts. Classic silver is the original, and the Brass is the upgrade. The upgrade features a different hole pattern on the grill/vent, as well as a spring-loaded ball-bearing lock to prevent the insert from...

BUMP

1 down 9 to go

THE INTEREST THREAD IS NOW LIVE

Good morning, After much work, trial and error. I am gauging interest in a small run of ten (for now) on the lighter used in the far-too-short-lived NBC Constantine series and subsequent Arrowverse appearances. These are laser-engraved brass Zorro lighters. I'm doing these with Zorro Lighters...

so i was planning on doing a run of ten of these lighters starting at the end of the month, but it seems that the Junkyard rules and requirements have changed since I last sold something on here.

I don't suppose you Measured that board did you?

i'm partial to the series 4 sonic construction, I always seem to miss out on the builds or kits

100 on the top and sides, 150 for the front and back

I fixed the alignment and dimensions, and dialed in the perimeters, gave it a close to mirror finish. Let me know what you think!

I got a new fibre laser for this because I wasn't a big fan of the acid etching and I tested this on one of my last Zorro 902 lighters. I re-did the art again, and I think I have a total of 80 hours in just re-doing the graphic, but this time I did it in a vector file to work better with the...

It is resin, so it stands to reason that you should easily be able to put a little elbow grease into it to make it accurate

Long time watcher first time caller here. I'm not sure if this one counts, but this is the 2014 Constantine Series lighter. It's a Brass zippo armour that I sanded, painted, lasered off the paint to make a mask, acid etched, and finally polished.