Next I inserted the shroud and the larger bracket piece into the tube. The Heiland clamps went on. These went on for looks but also tightened the shro
Next I inserted the shroud and the larger bracket piece into the tube. The Heiland clamps went on. These went on for looks but also tightened the shro
First I took the bottom fitting of the Canon clamp and put the rod through. I used a small bracket fitting to tighten it further. Then I put the gear
Here is a picture of the saber next to my Roman Props Obi Wan saber.
Here are all of the pieces I used that went into it. I used a 1/4 threaded rod, a canon model Y flash, a vintage Ranger flashlight, a vintage industri
I took a blow torch a few of the materials to age and darken them.
Also looking for a piece to go into the shroud for the emitter.
Still looking for a good piece to fir into the clamp, like circuit or bubble strip.
M

Next I inserted the shroud and the larger bracket piece into the tube. The Heiland clamps went on. These went on for looks but also tightened the shro

There are no comments to display.

Media information

Album
Found Parts Lightsaber Build
Added by
MattBud
Date added
View count
674
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top