First I took the bottom fitting of the Canon clamp and put the rod through. I used a small bracket fitting to tighten it further. Then I put the gear
Next I inserted the shroud and the larger bracket piece into the tube. The Heiland clamps went on. These went on for looks but also tightened the shro
First I took the bottom fitting of the Canon clamp and put the rod through. I used a small bracket fitting to tighten it further. Then I put the gear
Here is a picture of the saber next to my Roman Props Obi Wan saber.
Here are all of the pieces I used that went into it. I used a 1/4 threaded rod, a canon model Y flash, a vintage Ranger flashlight, a vintage industri
I took a blow torch a few of the materials to age and darken them.
Also looking for a piece to go into the shroud for the emitter.
Still looking for a good piece to fir into the clamp, like circuit or bubble strip.
M

First I took the bottom fitting of the Canon clamp and put the rod through. I used a small bracket fitting to tighten it further. Then I put the gear

There are no comments to display.

Media information

Album
Found Parts Lightsaber Build
Added by
MattBud
Date added
View count
526
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top