Fly4v
Sr Member
While Disney may want more Star Wars in their parks they unfortunately stopped selling one of their best contributions the franchise the park exclusive electronic E-11 blaster.
I was able to get one just as they were being removed from the parks.
I have already repainted the trigger, started painting the scope, cut off the orange tip, original front sight guard and trimmed the top T-track.
Too bad they are so expensive now on the secondary market. It is a shame to cut it up.
For the missing T-track i will be using the tines from a rake that were straightened in boiling water.
The metal ring is a leftover from a Captain America build and the new front sight guard is a spare from a Nerf First Order E7-11 mod.
Drilled out the holes in the bottom of the folding stock.
Drilled the one missing vent hole, carved back the preexisting T-track and made the flash guard from a piece of PVC pipe.
The holes will be covered with the rake T-track but I can also reuse the clear barrel liner and seal the holes by reinstalling it backwards.
The added vent hole is just over the leds and circuit card. I don't know if I want to move the electronics back.
This will be a slow build.
To be honest, it may be no more than a simple repaint made with scrapes since any of a non-existant prop budget will be used for my Arrow season one Bow.
I was able to get one just as they were being removed from the parks.
I have already repainted the trigger, started painting the scope, cut off the orange tip, original front sight guard and trimmed the top T-track.
Too bad they are so expensive now on the secondary market. It is a shame to cut it up.
For the missing T-track i will be using the tines from a rake that were straightened in boiling water.
The metal ring is a leftover from a Captain America build and the new front sight guard is a spare from a Nerf First Order E7-11 mod.
Drilled out the holes in the bottom of the folding stock.
Drilled the one missing vent hole, carved back the preexisting T-track and made the flash guard from a piece of PVC pipe.
The holes will be covered with the rake T-track but I can also reuse the clear barrel liner and seal the holes by reinstalling it backwards.
The added vent hole is just over the leds and circuit card. I don't know if I want to move the electronics back.
This will be a slow build.
To be honest, it may be no more than a simple repaint made with scrapes since any of a non-existant prop budget will be used for my Arrow season one Bow.