need help with finding a pressure pot replacement lid

E=MC2 said:
Thanks, but I tried that. :(
Click to expand...
Sorry. Only other thing I can think of is to search ebay for a lid, maybe someone out there has a bad pot with a now useless lid.

You cued say that, but happen is the lid at 130 PSI blue the lid right off with.
So my lid got destroyed !
Click to expand...

What pot is it by the way? There aren't too many rated for that kind of pressure, and they are mucho expensive.
 
What kind is it?

I have switched to vacuum, no longer using pressure so I only use the lower half of my pot as a vacuum chamber if necessary.

- - - Updated - - -

Wait, didn't your pot have a check valve?
 
Yup. Unless it is obvious that one of the clamps failed; major structural failure of the pot or lid itself is indicative it is a goner.

Regards, Robert
 
for the price you will pay to get a lid, you can buy a good pot, I just got two 2.5 gal. ca tech. pots for a steel.
you've blown the top off your pot, the clamps have to be deformed to some degree and are now unsafe. your life is worth more than a $100 pressure pot.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Riceball
Need help with Academy God Phoenix lighting kit
Replies
3
Views
698
Mr.Engineer
Mr.Engineer
spudkopf
Replacement Parts for the Hasbro Black Series T-47 (Snow Speeder)
2
Replies
20
Views
1,610
joberg
joberg
Redfinger
Need some scratch building advice!
Replies
4
Views
436
joberg
joberg
hoggworks
Getting started with LEDs
Replies
12
Views
579
rjenkinsgb
rjenkinsgb
3Dsf
LED filament with both connectors at the same end
Replies
4
Views
239
3Dsf
3Dsf
Back
Top