CynderBloc
Active Member
Not sure if this thread is in the right place.....so please move as necessary
Title says it all, I really hope it's possible or I'm snookered.
The build I'm working on has 2 pieces that can slot together to make one large piece. One piece is fine, but the other is not. Normally I wouldn't mind as the bow is not too extreme (but it is noticable where the pieces join). It's not for me though, so I don't really want to hand over a defective piece...
I don't have time to rebuild the bowed piece so I'm hoping that I can straighten it out enough. I thought maybe by clamping it down on a flat surface and brushing resin onto it, it could hold the bow, resin permeates quite far into the fibres.
Thought I'd ask in here first to see if anyone had a better idea
Title says it all, I really hope it's possible or I'm snookered.
The build I'm working on has 2 pieces that can slot together to make one large piece. One piece is fine, but the other is not. Normally I wouldn't mind as the bow is not too extreme (but it is noticable where the pieces join). It's not for me though, so I don't really want to hand over a defective piece...
I don't have time to rebuild the bowed piece so I'm hoping that I can straighten it out enough. I thought maybe by clamping it down on a flat surface and brushing resin onto it, it could hold the bow, resin permeates quite far into the fibres.
Thought I'd ask in here first to see if anyone had a better idea