youngwm
Active Member
I am installing fiber optics in a FM y-wing and after speding last night getting the lights wired and setup today I planned on installing the fiber in the cockpit then paint. I ordered 7ft 64 strand, I went to Home Depot today and bought the smallest bit that dremel offers.
Drilled holes where I thought fiber would look good in the dash and around 6 to 7 holes then I broke open the fiber jacket and the strands are smaller than the holes I could fit prob 6 strands of the optic in each hole. Is that ok to run several strands and then cut them off after glueing? I bought a safe glue that will not melt the fiber. If you have any advice please respond as my project is on hold till I figure out my next move.
thanks,
MY
Drilled holes where I thought fiber would look good in the dash and around 6 to 7 holes then I broke open the fiber jacket and the strands are smaller than the holes I could fit prob 6 strands of the optic in each hole. Is that ok to run several strands and then cut them off after glueing? I bought a safe glue that will not melt the fiber. If you have any advice please respond as my project is on hold till I figure out my next move.
thanks,
MY