jediknight0
New Member
Frequent lurker, occasional poster here.
So I've been using liquid resin for years for various replica projects and computer case modding, but I want to step up my game. I've been looking into either getting a vacuum chamber or a pressure pot and I think I've leaning toward a pressure pot... but if I use a simple venturi pump (for $15 for harbor freight) going from pressure pot to vacuum pump is simple. But both require a good air compressor.
So any recomendations for cheap, good, and possibly local (i.e. sears, home depot, lowes, harbor freight) air compressors?
Ideally my requirements (in no particular order) are:
1) physically small
2) high CFM
3) cheap
4) lightweight
5) low AMPS (short story: my garage shares one 15 AMP circuit with half my condo and it's hard to change for variosu reasons)
I know - some of those requirements are at odds with with other. I'd say high CFM & low AMPS are probably the most important.
Any help? Thanks in advance.
So I've been using liquid resin for years for various replica projects and computer case modding, but I want to step up my game. I've been looking into either getting a vacuum chamber or a pressure pot and I think I've leaning toward a pressure pot... but if I use a simple venturi pump (for $15 for harbor freight) going from pressure pot to vacuum pump is simple. But both require a good air compressor.
So any recomendations for cheap, good, and possibly local (i.e. sears, home depot, lowes, harbor freight) air compressors?
Ideally my requirements (in no particular order) are:
1) physically small
2) high CFM
3) cheap
4) lightweight
5) low AMPS (short story: my garage shares one 15 AMP circuit with half my condo and it's hard to change for variosu reasons)
I know - some of those requirements are at odds with with other. I'd say high CFM & low AMPS are probably the most important.
Any help? Thanks in advance.