Well, I did one ear. I
tried to level it in Blender bit did not do that great a job. While the print itself went good, the angle I had it at made it look
terrible
View attachment 266067View attachment 266068
I was able to rotate the other parts in good ways for the print, and will try them later this week. But I wanted to get the ear to lay
flat on the printbed, and did not.
Would it be possible, drumguy560, to post the ears laying completely flat? :$ I think this would make them look the best after print. I just can't, try as I might, get it to lay flat in Blender (or Sketchup). The Cura program mentioned earlier
does have an easy feature to do this, but sadly is not compatible with my printer. I would greatly appreciate it if you could.
I've arranged the other parts already, and will keep printing as the week goes on. Pictures to follow.