Hi Gang,
Early Morning Update!
Didn't get as much done as I would have liked this weekend. Too many hurdles and other life's little distractions got in the way...
Added filler to he arm rest supprts - that going to be a LOT of sanding
Work continues on the 3 nav chair headrests - lots of mods to this file over the weekend (very frustrating)
And mishaps...
Every now and then Home Depot sells a sheet of MDF that is beyond terrible... This sheet would NOT laser cut without changing many of the settings
Trying to piece it all together
Details
I like it but probably wont use it
Basic setup
Front side
I trimmed the Lid
Dry fit
It will actually lean forward just a bit
PRIMER!
After making a few mods I cut three new headrests
Trying to put everything together
This angle bracket serves a small detail
While filler and primer dried I then put these greeblies together
I had to laser cut these new pieces to allow for more travel when bolted in place
I added super blue to these edges
Then primed
Spent a few hours CNCing the nav chair seat pads and trim piece
The seat pad itself will sit down into the recessed area
I then routed the edges
Added filler
And this is where we are!
Another HUGE thank you to Daniel for sacrificing a few hours on Sunday to get these parts cut!
Stand By! More to Follow!