Johnnymuffintop
Well-Known Member
Re: Star Trek: Into Darkness "Concept" Phaser by Kenney's Custom Props, LLC
I'll take a dozen!
I'll take a dozen!
redshirtKenney, can we tumble polish the raising P1 clear part? I'd like to laser etch that sighting pattern on to that part.
redshirt...... the 3d printed clear plastic will yellow over time if exposed to direct sunlight. Mainly because ultra violet light is what actually cures the plastic. So, with that said.... I would pull a mold off the part and cast it in a clear 2 part resin with UV properties. Smooth On has some good stuff to use. You can laser etch either the Smooth On stuff or the 3d printed part because I do it all the time. As for the jewel.... looks good. FYI... all of those little "indents" on the dial are supposed to light up as you would spin the dial. Basically, increases power. But, It's not etched in stone so you do whatever you want the concept to be like.
a ton of stuff I did for the new Godzilla film