Total Recall gun

Thread starter Ki Djowac
Start date Sep 30, 2012

ogrotesque1

Active Member

Jul 9, 2019

Hello, you did an amazing job on this! By chance do you still have the files for the schematics to your final version of this compensator? I’d like to try and get one made out of gun grade aluminum for a real Beretta 92A1. I’m sure some small treaks will need to be made like a countersunk guide rod hole in the front as well as removing the two set screw holes, but that’s not a problem. This compensator would be a show stopper at the range for sure! Thanks in advance.

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.