Terrahawks cube scratchbuild

Thread starter KevinD
Start date Jan 28, 2019

KevinD

Sr Member

Jan 28, 2019

Just finished a scratchbuild of one of the Cubes from the Gerry Anderson series Terrahawks. These evil robots ought to be easy as they are boxes! However, the sloping sides meant I had to cut tubes lengthways and the corners were hemispheres cut in four! The finish is a paint effect to try to look like the unpainted fibreglass they seem to be made from. Oh and I put a light in it!

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.