I'm surprised I didn't see any other threads about this costume, just the one about the sheild. I hope this isn't a duplicate.
Anyways... I took a long while off making stuff and I'm getting back into it with a simple-ish project — a 3D printed Soldier Boy helmet. There's still some polishing and I need to clean up the ridges, especially where they meet along the bridge of the nose, but I'm super happy with this so far! This fits tight on my head, which is about 23" if I measured correctly, so this is probably the best I've ever done on scaling a model as well. There was quite a bit of post processing, especially the texture on the eagle which is made from styrene, but this is base 3D model I purchased. I'm planning on making some castings of this, as well as finishing a few with the WWII Captain America style straps, even though these don't ever appear in The Boys show.
Anyways... I took a long while off making stuff and I'm getting back into it with a simple-ish project — a 3D printed Soldier Boy helmet. There's still some polishing and I need to clean up the ridges, especially where they meet along the bridge of the nose, but I'm super happy with this so far! This fits tight on my head, which is about 23" if I measured correctly, so this is probably the best I've ever done on scaling a model as well. There was quite a bit of post processing, especially the texture on the eagle which is made from styrene, but this is base 3D model I purchased. I'm planning on making some castings of this, as well as finishing a few with the WWII Captain America style straps, even though these don't ever appear in The Boys show.