Sentry Interface (ME 2/3) test image for print..Opinions

GCBrokawV2

GCBrokawV2

New Member
So I created the visor image that I will print at my work on plastic covering on a flatbread printer. This is my first build. Waiting for materials to arrive. My goal is to have the LED's make the blue pattern pop a little when lit up cant wait! Please give me feedback on what I have so far.... Cant wait to show finished product.

also added reference pics...
printableinterface.jpg

sentry2r.jpg

sentry1z.jpg
 
Last edited:
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Cieszlak
Ideas for me to cosplay?
Replies
8
Views
443
real9thdoctor
real9thdoctor
AstroChrisX
Accurate B-01 Tactical Armour (Helldivers 2)
Replies
0
Views
60
AstroChrisX
AstroChrisX
lmgill
For all you Space Shuttle fans.. STS-2 - STS-4 helmet / suit display.
Replies
1
Views
94
Leinads
Leinads
AdamCastanon07
Question about the Tasm 1 suit print file.
Replies
0
Views
323
AdamCastanon07
AdamCastanon07
MorbidCharlie
Immortan Joe - Fury Road / Furiosa (Boots Done 3/27)
Replies
17
Views
1,929
MorbidCharlie
MorbidCharlie
Back
Top