Agentsmith350
Active Member
Been having a fiddle with an 11th sonic and have came out with this fairly easy :
What i did was strip out the spring and clips , rewire the bottom button to a switch on the handle that i had cut a square out for and epoxy'd in. attached magnets to the bottom of the sliding section and inside the handle with epoxy so that it can be held closed then dabbed a little epoxy on the bottom of the claws so they close much better against the green emitter. Hope you like it !
What i did was strip out the spring and clips , rewire the bottom button to a switch on the handle that i had cut a square out for and epoxy'd in. attached magnets to the bottom of the sliding section and inside the handle with epoxy so that it can be held closed then dabbed a little epoxy on the bottom of the claws so they close much better against the green emitter. Hope you like it !
Last edited: