Chrisisall
Sr Member
I'm gonna run the FO through the tube & put a tiny dab of epoxy on the end, should have the right amber look to it.
I cut them with an X-acto knife, the flat bladed one so I could chop them, then I used a needle nosed pliers to bend open the ones that got a tiny bit flattened.How did you bend those those tiny tubes? I have mine now and wondering how i am even going to cut the to length they are so thin!
I make it up as I go. I might sand spots in between the two plates to make the necessary space for the LEDs... one dude actually sanded the LEDs themselves, but I'm not too comfortable with that.How do you intend to get any form of lighting between those two top plates?
I make it up as I go. I might sand spots in between the two plates to make the necessary space for the LEDs... one dude actually sanded the LEDs themselves, but I'm not too comfortable with that.
Very brave, more than i would risk!