Mark 46 build 3D print

Thread starter TKCC71
Start date Mar 18, 2016

ariksu

New Member

Sep 4, 2019

#441

ubcs86 said:
TKCC71, let me know if you'd rather have me make my own post on this so I dont hijack/muck up your build post!

I had a mis-print face shell that I'm using as the test dummy (actual is in paint at the moment). Model of the assembly and actual photo. I'm printing a generic dual servo mount that I found on thingiverse that I will test the fit. So far it's looking a tad wide, but we will see.
View attachment 640904 View attachment 640905 View attachment 640906

any chance you have this file available?

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.