Check out the run of steel or aluminium barrels Teddz is doing on the project runs page. He's got all the dimensional info from DaveG's published blueprints and some pics of my steel one.
You know, I actually found his run thread about an hour after I asked this and had meant to come back here and edit my original reply sooner (could have sworn I had checked the project runs section before posting). Anyway, I'll be sure and see about getting in on that run!
Glad you found the run for the barrels and the cylinder.
If your receiver is the matte one, then White vinegar should do the trick. Just keep in mind it can take up to an hour ( give or take) to see full results. You can help the process going over your parts with some steel wool after 20 to 30 minutes.
Let me know if you need any help as you go
Are those grips just painted? Looks nice!!
the binding post is one of the few that continues to elude me...
Look up EE-8 army phone. [emoji106]Should run $30-$50.
Ironically, your reply immediately lead me right back to Propsummit (I swear I looked for this there before asking here, but the Summit's search feature is... subpar) and the thread where Prime586 did that spectacular breakdown of the post's history. Anyway long story short: I'm way better armed to track one down now than I was before, so thanks for that, Veektohr!