Started lighting...I harvested some "flickering LED's" from these dollar store "tea lights"...these will drive new LED's....
Built a test circuit board with four colors of LED's, including red, purple, yellow and green for a "spooky" random flashing effect inside....Aware that some are not interested in the electrical/lighting phase, I'll stop here on this subject, unless interested parties want a detailed explanation of how it's wired.....
The brick walls were ready to receive some attention. The mortar mix is a very watered down Liquitex Modeling paste.
I brushed it on and immediately wiped away the excess with a finger.
At the same time, I'm building a base from 7/32" (5.5mm) plywood. Just enough room around the model perimeter for a side walk in the front & right sides, and some grungy alley neglect on the back and left side. Power jack on the right.
Building up two coats of drywall compound & will scribe expansion lines into later...
The wiring is concealed thru the chimney chase, and under the base to meet up with the DC power jack.
I'll be using a 12 volt wall wart.
Till next time...