Any views on poly-optic 1411?

Thread starter andy19422
Start date Sep 15, 2013

andy19422

Sr Member

Sep 15, 2013

I want to cast some small light lenses in a moldstar15 mold using tinted clear resin. I have tried a resin that has a pot life of only a couple of minutes, but this leaves a lot of small bubbles trapped in the cast. I have also tried one that has a pot life of twenty minutes but takes a week to cure. I want to try poly-optic 1411 as this has a pot life of nine minutes and quick demold time. I don't have a vacuum degassing tank so the resin should degass itself. Has anyone used it and what are your views on it please.

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.