3D Printers for Modelers?

Thread starter Odysseus
Start date Mar 11, 2024

TazMan2000

Master Member

Mar 20, 2024

Odysseus said:
Thank you all for your comments and suggestions. I will be setting up my resin printer in my garage with a grow tent and small space heater for cold days. It has room for the wash and cure stations as well.

One more question: once prints are cured, is there something I would need to coat the pieces with in order for acrylic paints to adhere? I presume any of the typical clear coats from Testor's or Tamiya would suffice.

As long as the parts are washed well in isopropyl afterwards there should be no issues with acrylics, or any other kind of paint, adhering. I will admit though, I've never tried oils.

TazMan2000

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.