Viper launch tube for the Revell colonial Viper

E=MC2

Sr Member
I am making a 16" Viper launch tube for the Revell colonial Viper.
Here is what I have so far, the launch cradle was the frist to do.
Now I am geting to the 2 bulk heads and I am looking at the one in the TV show.
It is not easy to find some of the model parts that they used, but I am going to do the best I can. I will make molds and kits as well.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top