Luke ROTJ Lightsaber Comparison between Rylo and Nicksdad

rabbit4x

Sr Member
I had some time today while trying to figure out how the Rylo kit disassembles and after I did that, took some pics of the parts breakdown. Taking a note from Tridcloudwalker, this is just to show the subtle differences between two really well made saber kits as well as show the parts breakdown for future saber makers.

f6e538e4.jpg

07bc25d1.jpg

4450f681.jpg

9346a91c.jpg

21a7c6b0.jpg


Pommel:
41a28d2d.jpg

b42ee544.jpg

d0ffe2ff.jpg

47264f49.jpg

b21146bf.jpg

fb59175f.jpg

57094cc0.jpg

cb1f7d9f.jpg


Rings:
7b3382f3.jpg

0d5e530f.jpg

4e2ab895.jpg

b27ac8a3.jpg

68b5646b.jpg

ffc64672.jpg


Emitter:
32240177.jpg

3bd28590.jpg


Threaded Rod that holds the sabers:
e143d67d.jpg


Neck Area:
35104871.jpg

bcb7d47e.jpg

8884dd17.jpg

1f99d195.jpg


What's interesting is that both are very close/almost exact in diameter.
36de083c.jpg


Neck part2:
c593b58f.jpg

1e15aa21.jpg


Control Box:
64e1a0b4.jpg

5430a238.jpg

2698c40c.jpg

dd82222b.jpg

6e17bfe0.jpg


Control Box doodads:
4d0ef5dd.jpg

ed646d9b.jpg

ed394e9c.jpg
 
Very nice kits! They both look great, though I think Rylo nailed the hole for the loop for it to hang from a bit better.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top