iron man mark 46 bust

Thread starter Frid4y
Start date Oct 16, 2018

Frid4y

Member

Oct 16, 2018

hi guys I would like to make a mk46 1:1 bust for my room and I already have the helmet completed which is casted in resin. I wonder if anyone here has the material to cast the bust and a part of the back and of course the neck. I have a 3D printer Anet a8, I tried to make the surface smooth with different materials but with no good results. for this reason I prefer some resin casting for this three pieces. If you guys have some tips please tell me

the pic down here shows the result I would like to accomplish.

https://images-na.ssl-images-amazon.com/images/I/51hHxer8pdL.jpg

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.