Pepsi Perfect Scratch Build

IxMAGICx1

Well-Known Member
bottles.jpg

I learned a lot making the Diet Pepsi Perfect. That golden bottle in the picture is going to be a Pepsi Perfect. I have Roland's vinyl decal I'm going to use on it. Unfortunately with 3D printing, even if you use a "clear" filament it's not going to be anywhere near clear. So I'm going to go with a glossy black and see how it looks. I think it's going to look just fine.

I'll be documenting my progress in this thread. If all goes well, the next thread will be the Slice bottle
 
The bottles are all primed and sanded. ready to paint tomorrow.

I was eager to work on a mini bottle today as well so this happened...
(this is the pink bottle in the picture above)
1.jpg2.jpg

I'm currently working on the logo (and Slice logo) but for now, here's Roland's logo photoshopped on showing pretty much exactly what it's going to look like complete.

2-withlogo.jpg

I'm thinking of making a complete set (Pepsi perfect, Diet Pepsi, Slice) and making them into Christmas ornaments or just miniatures to display. If there's interest I'd sell them as well.
 
Last edited:
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top