propmaster2000
Sr Member
A few days ago, I set out to design another possible 3D printed prop.
I personally have never seen the actual prop or even a replicated version.
There are several screen captures on line that give some pretty good close-up shots
but hard to get the proper scale.
I will most likely use a Velcro attachment to the uniform or I have even considered using strong magnets in the base
and a thin metal plate under the fabric.
To achieve the "vapor" effect, I will use small chips of dry ice in a removable tray in the mouth piece with small vent holes.
Amber LEDs will also be added as I progress but won't happen until I am satisfied with how it prints.
https://www.youtube.com/watch?v=MG-wuwY1yEY
I personally have never seen the actual prop or even a replicated version.
There are several screen captures on line that give some pretty good close-up shots
but hard to get the proper scale.
I will most likely use a Velcro attachment to the uniform or I have even considered using strong magnets in the base
and a thin metal plate under the fabric.
To achieve the "vapor" effect, I will use small chips of dry ice in a removable tray in the mouth piece with small vent holes.
Amber LEDs will also be added as I progress but won't happen until I am satisfied with how it prints.
https://www.youtube.com/watch?v=MG-wuwY1yEY
Last edited by a moderator: