Need ANH Chest Box rods 3d printed or 3d model

Unless someone else has/found one already, I could do a model for you but I'd need to find accurate measurements first. I'll look more into it later.
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Anakins father
Lightsaber 3d modeling and blueprints
Replies
3
Views
518
Ridire Firean
R
Raaven1990
How durable is a DIY Vader saber with 3D printed parts?
Replies
15
Views
610
SPY007
S
AirMech74
My first DIY-3D printed Lightsaber...Baylan Skoll
Replies
3
Views
975
Ghostsoldier
Ghostsoldier
JiminSTLouis
3D Printed Naboo Short Barrel Blaster
Replies
3
Views
621
JiminSTLouis
JiminSTLouis
DracoAdamantus
Bad Batch - Looking for Crosshair belt buckle (physical or 3D model)
Replies
14
Views
1,067
Dbb4000
Dbb4000
Back
Top