tarnyloo73
Well-Known Member
Finally getting version 2 of the Tyrannosaurus skull on Shapeways. If you've been following the W.I.P. thread you'll be aware it's part of a larger collection of models. Initially only the skull and foot are ready. This weekend I'm preparing the neck/skull and dual-detail versions which I hope to roll out over the next few days.
I've probably held on to this far too long but I really wanted to have actual photos (not 3D renders) before I put this out on Shapeways. As always Russell at Mushroom Imaging did an excellent job getting some good angles and capturing fine details.
Had an busy evening yesterday sizing the 7 scale versions for the skull and foot. There's sometimes a bit of tweaking required to get the smaller scales past Shapeways checks.
Shapeways links here-
Tyrannosaurus skull on Shapeways (version 2)
Tyrannosaurus foot on Shapeways
Examples shown in photos are 1:20 scale, brush painted with artist's acrylic paint and lightly coated with a compatible gloss varnish for protection. Display stands are perspex and 2mm piano wire.
More stuff coming soon.
I've probably held on to this far too long but I really wanted to have actual photos (not 3D renders) before I put this out on Shapeways. As always Russell at Mushroom Imaging did an excellent job getting some good angles and capturing fine details.
Had an busy evening yesterday sizing the 7 scale versions for the skull and foot. There's sometimes a bit of tweaking required to get the smaller scales past Shapeways checks.
Shapeways links here-
Tyrannosaurus skull on Shapeways (version 2)
Tyrannosaurus foot on Shapeways
Examples shown in photos are 1:20 scale, brush painted with artist's acrylic paint and lightly coated with a compatible gloss varnish for protection. Display stands are perspex and 2mm piano wire.
More stuff coming soon.