Deetz
Active Member
My finished Scout Trooper helmet, printed on my Makergear printer. Lot's of sanding and bondo on this one with all of the sections I printed. The overhangs on the dome needed a ton of support so I used a few more sections to save on material. I built the helmet in Modo and I used simplyfy3D to print it.
The last 3 images are a couple of renders from Modo of the model. I didn't print the vocoder, though it's shown on the render. It was just easier to buy an aerator for a faucet and paint it. Anyway, this is the finished helmet, all polished up.
The last 3 images are a couple of renders from Modo of the model. I didn't print the vocoder, though it's shown on the render. It was just easier to buy an aerator for a faucet and paint it. Anyway, this is the finished helmet, all polished up.