3D Printed Sword of Omens Questions (Thundercats)

KCollar

New Member
Hello!!

I am having a 3D Printed Replica of The Sword of Omens made and I was wondering if anyone here would know the colour palette for accurate Cartoon Colors for it.

I could do just a normal red, black...etc but I'd like a somewhat accurate colour on the thing. Any Suggestions?
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top