Star Trek - Deep Space 9: Quark's Box with Isolinear Rods build, Part 1

Cmdr.Kerner

Cmdr.Kerner

Master Member
Hi guys,
here is my latest build. The material is 3 mm thick red PVC hardfoam.
 

Attachments

  • 0.jpg
    0.jpg
    55.4 KB · Views: 241
  • 9.JPG
    9.JPG
    1.3 MB · Views: 206
  • 8.JPG
    8.JPG
    1.2 MB · Views: 221
  • 7.JPG
    7.JPG
    1.1 MB · Views: 207
  • 6.JPG
    6.JPG
    1.3 MB · Views: 225
  • 5.JPG
    5.JPG
    1.1 MB · Views: 221
  • 4.JPG
    4.JPG
    1.1 MB · Views: 214
  • 3.JPG
    3.JPG
    1.3 MB · Views: 198
  • 2.JPG
    2.JPG
    1.1 MB · Views: 187
  • 1.JPG
    1.JPG
    1.3 MB · Views: 227
Last edited:
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Tripper
Star Trek TOS Fiberglass Midgrade Phaser Build
Replies
10
Views
1,177
WinstonWolf359
WinstonWolf359
Jastor00
Star Trek: TNG MkVII Science Tricorder Build
2
Replies
24
Views
2,221
Jastor00
Jastor00
alexbailey
Star Trek - Nomad Probe
Replies
5
Views
429
alexbailey
alexbailey
MCP935
Star Trek TR-580 Resin Tricorder
Replies
6
Views
1,193
publiusr
P
KevinD
Space 1999 clock
Replies
4
Views
223
KevinD
KevinD
Back
Top