Avatar SN-9 Wasp

Helix6187

Well-Known Member
Hi everyone !

This is my try to do a SN-9 Wasp. The size is based on the wikia (caliber and round capacity too, most of the modeling is based on the weta paper design)

sn_rpf10.jpg


sn_rpf11.jpg



I still need to make the rear selector.


And this where i am on the physical model. Sand, prime, repeat :lol.

img_2931.jpg


img_2932.jpg



Thanks for watching.
Helix
 
Last edited:
Little progress.

img_3513.jpg


img_3514.jpg


I'm not totaly sold on my green mix, maybe a tad too dark.


img_3515.jpg


First pull of the handle grip painted with a semi gloss black.


img_3516.jpg


I will add the missing screws on the selector with real hardware later.


TO DO:

- Cast clear lens
- Add knobs to the scope
- Screws
- Cast the bits that retains the lamp and scope to the rails
 
Last edited:
How does it stay closed? or is the final build intended as static with no moving parts?

Collektor

Neodymium magnet are holding it closed.
The scope is removable ( you can see it's not correctly aligned witth the barrel).
The flashlight is removable as well.
The cylinder is removable as well and can be loaded with the caseless 9mm round that I have not yet printed.

The trigger is glued in place but it's fonctionnal on the 3D file, It was just a matter of taste here.



[Edit]

img_3610.jpg


img_3611.jpg


I dissassembled it for a bit more sanding some lines were still visible on the rails.
 
Last edited:
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top