Episode 3 Jedi Fighter 1/58

joeydee

Active Member
The Revell Easykit Pockets were a gift, they got a repaint, some battle damage, and I scratched some droids for a little display.
Droid height is 30mm.
The Background is a printed image from the original scene.

Not my favourite movies and designs, but somewhat colorful among all that weathered spaceship grey ;)

i50988b8bgxi.jpg


i50982buiyg2.jpg


i50983byrpj4.jpg


i50984b1labq.jpg


i50985btqf6t.jpg


i50986bnz85d.jpg


i50987bj5nr7.jpg


i50978bcfjes.jpg


i50979boymci.jpg


i50980b3psnk.jpg


i50975b76bjm.jpg


i50976bhevt9.jpg


i50977bkxunm.jpg


i50974bmku5r.jpg
 
Awesome stuf. I like and know these kits, but the droids are something else!

I was going to ask if you had moulded them, but hand-cutting all required parts is vastly more impressive. And also quite mad.:p

You certainly nailed it with those droids though; they're absolutely great.

The only comment I could have is that the Jedi leaping from his cockpit is too static in his pose right now, but hey; the force eh? ;)
 
Moulding was a thought, but there was not much to win. Body, legs, arms and head might have to be separate parts. Cleaning up, filling bubbles, failing parts, and posing those tiny resin bits would have been nearly the same amount of work, but less stable.

The pose: yes, I tried, but the original sitting pilot figure is just a plastic clump, was hard to pose.
Ok, now it's something in between this:

and that:
;):lol
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top