Uther Pendragon's crown

Thread starter foldart
Start date Aug 15, 2018

foldart

Active Member

Aug 15, 2018

Because my daughter wants to do a joint cosplay as Uther and Arthur from BBC Merlin . . . .

Here's Uther's crown:

4mm EVA ring, reinforced at the joint with craft fabric:

Gold filigree Simplicity trim glued around the band:

Bead of gold roping:

Upright EVA panels covered with the same trim:

Way too shiny for Uther, so distressed with acrylic:

Close enough!

Last edited: Aug 16, 2018

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.