Whats the best way to adhere foam filler to silicone skin?

QA714

New Member
So Im making a silicone cast and I'd like to fill it with Foam-It 10, is there anything I have to do to make them bond permanently or will the foam just do that naturally(I know silicone bonds to very little)



edit as to not make a new thread : Also is Ease Release 205 basically the same as 200( other than aerosol vs. liquid) or do I need to seal my silicone rebound 25 mold beforehand when using 205?
 
We normally lay cheeseloth or loose weave burlap/ Hessian into the last silicone layer while its still still wet but just place it in...dont cover it over....
That way the burlap sticks to the silicone and the foam sticks to the burlap.

Johnny
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top