Low budget 1:6 scale endoskull (mod)

mlasschuyt

New Member
I've ordered a endoskull very cheap from AliExpress and made my own custom battle damaged version.

It all started out with the Antique Silver version of the Keychain Terminator skull:
HSIC-Brand-Terminator-Keychain-Keyring-Three-dimensional-Punk-Keyring-Cool-Skull-Mask-Key-chains.jpg

I took the keyring off with a dremel. I than polished it a bit with an inox brush:
IMG_5471.jpg

I added the pistons and some wiring. I've added some scorching and coloring with a lighter:
IMG_5499.jpg

Last but not least I've drilled out the eye sockets and put in some clear lenses (from a bag of silica gel balls):
IMG_5514.jpg

And voila, a very low budget Terminator scaled prop!
It is just a bit bigger than 1:6 scale, but it looks good with a 12" figure:
IMG_5511 (2).jpg
 
Last edited:
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top