Iron Giant Mini Bust

Kaptainkirk

New Member
Hey Fellow sculptors!

Just finished up my Iron Giant Bust. Just needs a few clean ups and ill start casting them.
My plan is to mold it, cast it, then with the copies use some of that metal powder coating so it gets
a nice gun metal finish.
Should come out looking pretty nice!
But after a lot of work and smoothing, I think hes just about done, just needs some cleaning up!
Also I'm including a picture of before the final details to show everyone how i plan on finishing him.
He's basically going to have an attachable arm so I can place a small kid in it.
Anyways, enjoy!

irongiant8 (2).jpgirongiant7 (2).jpgirongiant6 (2).jpgirongiant5 (2).jpgirongiant3 (2).jpgirongiant2 (2).jpgIrongiant (2).jpgiron giant 4 (2).jpg19274884_10213522220836913_1986483162021216379_n.jpg
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top