KAILUAZ
New Member
So I'm building some wound packing props for medical training and I'm running into issues with getting the power mesh to take. In the first photo (pardon my notes to myself) you can see the top "skin" peeled off where I laid it down. It was between the "meat" layer and skin layer. On the bottom photo I did a top pour and it caused an air pocket where the silicone didn't penetrate the power mesh.
I'm looking for ideas on how to better embed the power mesh into the silicone since the "mesh" is pretty tight and it seems the silicone isn't penetrating it well.
Materials are Dragon Skin 10 NV for the bottom "meat" and Ecoflex 00-30 for the top "skin". I also tried all Dragon Skin 10 and got the same peeling results. Thanks in advance.
I'm looking for ideas on how to better embed the power mesh into the silicone since the "mesh" is pretty tight and it seems the silicone isn't penetrating it well.
Materials are Dragon Skin 10 NV for the bottom "meat" and Ecoflex 00-30 for the top "skin". I also tried all Dragon Skin 10 and got the same peeling results. Thanks in advance.